Husqvarna 225i Manual De Usuario página 29

Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure that
it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to make
sure that it is not damaged.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
4. Do a check of the keypad (D) to make sure that it
operates correctly.
5. Make sure that there is no oil on the handles (E).
6. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
7. Do a check of the chain catcher (F) to make sure
that it is attached correctly.
8. Do a check of the chain tension (G).
9. Charge the battery (H) and make sure that it is
correctly attached to the product.
10. Make sure that the saw chain stops when you
release the power trigger. (Fig. 57)
To use the correct chain oil
WARNING:
which can cause injury to you and the
environment. Waste oil also causes damage
to the oil pump, the guide bar and the saw
chain.
WARNING:
if the lubrication of the cutting equipment is
not sufficient. Risk of serious injury or death
to the operator.
WARNING:
for this function to operate correctly. Speak
LED indicator
4 LED lights are on
3 LED lights are on
1860 - 002 - 30.11.2022
Operation
Read and understand the
Do not use waste oil,
The saw chain can break
Use the correct chain oil
Battery state of charge
The battery is 76% - 100% charged.
The battery is 51% - 75% charged.
to your servicing dealer when you select
your chain oil.
• Use Husqvarna chain oil for maximum saw chain life
and to prevent negative effects on the environment.
If Husqvarna chain oil is not available, we
recommend you to use a standard chain oil.
• Use a chain oil with good adherence to the saw
chain.
• Use a chain oil with correct viscosity range that
agrees with the air temperature.
CAUTION:
0°C/32°F some chain oils become too
thick, which can cause damage to the oil
pump components.
• Use the recommended cutting equipment. Refer to
Accessories on page 41 .
• Remove the cap to the chain oil tank.
• Fill the chain oil tank with chain oil.
• Attach the cap carefully.
(Fig. 58)
Note:
To see where the chain oil tank is on you
Introduction on page 20 .
product, refer to
Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Ambient temperature
Operation of the battery 5 °C-40 °C / 41 °F-104 °F
Charging of the battery 5 °C-40 °C / 41 °F-104 °F
Battery status
The display shows the state of charge and if there are
problems with the battery.
(Fig. 59)
In temperatures below
Read and understand the
29