SOMFY Sonesse 40 WF RTS Li-ion Instrucciones página 13

Sonesse 40 WireFree RTS Li-ion
3.8. BATTERY REPLACEMENT
͉
Somfy recommends replacing the battery with the same type available in the Somfy catalog. Using another type of
battery could result in system damage and voiding of the warranty.
Precaution
Replacement of the battery by an identical model only, must be carried out by a professional of the motorization
and the automation of the habitat.
Caution
• Do not use tools that could damage the drive when replacing the battery.
• Do not cut or damage the antenna cable.
1) If the drive is fixed to the tube, disassemble the motorised product to
access the self-tapping screws or steel pop rivets (motor drive wheel
side) and remove them.
2) Grab the drive head and pull out the drive by sliding it out of the
motorised product tube.
3) If necessary, remove the ring gear on the actuator tube to access the
two T8 torx screws or cruciform screws and unscrew the drive head.
4) Remove carefully the drive head from the drive tube taking care not
to damage the wires and disconnect the battery.
5) Grab and remove the used battery by sliding it out of the drive tube
taking care not to damage the wires.
6) Insert and slide the new battery into the drive tube, leaving the
battery connector accessible from the outside of the tube.
7) Connect the new battery.
8) Insert the drive head using the keying notches on the drive tube
taking care not to cut off the wires.
9) Screw the drive head using the two T6 torx screws or cruciform
screws to the drive tube.
10) Restart the installation in chapter 2.1.3. Drive/tube assembly.
͉
If necessary, readjust the end limits referring to chapter 2.4.2. End limit
readjustment.
Copyright © 2019 - 2022 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
10 10
=> 2.1.3. Drive/tube assembly
EN
11