Publicidad
Idiomas disponibles
Idiomas disponibles
7.2.
Installing the remote power-on unit (optional)
90 °C
1
60 °C
40 °C
Observe standard EN 60335 when operating the controller via the remote
power-on unit.
D
Enable the remote power-on function in 20 KEY service menu, see
system settings from page 27.
Only install the remote power-on unit in dry rooms and not inside the sauna cabin.
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ
1.
Run the wire between the remote
power-on unit and the controller.
2.
Press a screwdriver into the hollow (1) of
the lock while simultaneously lifting the
housing cover.
3.
Run the wire for the remote power-on unit
with a grommet through the holes into the
housing lower section.
4.
Fasten the housing lower section in the
fastening holes with screws (3.5 x 20 mm)
or with dowels.
5.
Connect the remote power-on unit as
shown in the wiring diagram.
6.
Hook the housing cover into the housing
lower section that has been mounted and
press down until it locks into place.
Page 22 / 104
Publicidad
