2.
GENERAL SAFETY PRECAUTIONS
Read and observe the operating instructions and safety precautions before commissioning.
D
Only install the sauna controller outside the sauna cabin!
D
Disconnect the controller from the mains before opening the controller housing.
D
The controller may only be connected to the mains by a locally authorised electrician.
D
Only connect the sauna unit directly to the mains voltage via a fixed connection in
accordance with VDE regulations. Use a residual-current circuit breaker I
with a contact gap of at least 3 mm in the connecting feed line.
90 °C
D
Please contact KLAFS customer service in case of a fault.
D
Remote operation (remote power-on unit): Setting, controlling and/or adjusting the
controller using a command or a remote control unit that is outside the range of vision
of the sauna heater. Remote operation (remote power-on unit) may be used only
together with the safety-contact switch (SCS) or the Bonatherm under-bench heater.
D
Only use original KLAFS spare parts.
D
Unapproved changes to the controller are not permitted.
60 °C
D
Install the controller in accordance with the installation instructions.
D
Electrical wiring inside the cabin and the cabin walls must have silicone insulation.
D
Before commissioning the controller, always make sure that there are no flammable
objects near the sauna heater or infrared heater in the cabin. RISK OF FIRE
D
Check the sauna cabin before restarting the timer or switching on the unit via a
separate remote activation system.
D
The unit can be used by children over eight years of age, by people with reduced
physical, sensory or mental capabilities and by people who lack
experience/knowledge in using it provided that they are supervised while doing so
and/or have been shown how to use the unit safely and understand the potential risks
involved. Do not allow children to play in the unit. Children should not clean the unit or
carry out basic maintenance on it without supervision.
40 °C
v 0.03 A
nN
Page 6 / 104