Stihl iMOW 5.0 Manual De Instrucciones página 63

7 Positioning the docking station
charging cable can be routed out of the base
plate to the left or right.
1
► Slightly bend the hood (1) toward the outside
on both sides and remove it upward.
► Press the retaining latch (2) and open the
cover (3).
6
4
► If you intend to connect the docking station
from the rear:
► Insert the plug (4) into the conduit (5) and
feed the charging cable (6) through.
Push the charging cable (6) upward inside
the docking station.
B
A
► If the docking station has been positioned
directly against a wall or you want to route the
charging cable underneath the base plate
toward the side:
0458-011-9801-A
3
2
5
A
B
4
6
► Open the edge and deburr it on the desired
side of the base plate at position (A).
► Cut out and deburr an opening in the center
of the base plate (B).
► Insert the plug (4) into the opening (B) and
feed the charging cable (6) through.
Push the charging cable (6) upward inside
the docking station.
6
4
► Secure the charging cable (6) in the cable
holder (7).
► Insert the plug (4).
The plug (4) audibly and noticeably engages
on both sides.
Securing the docking station
8
► Secure the docking station on the ground with
four ground pegs (8).
Feeding the perimeter wire
10
► Insert the beginning of the wire (9) into the
right conduit (10) and feed it through.
Push the perimeter wire (9) upward inside the
docking station.
English
7
9
63