Stihl iMOW 5.0 Manual De Instrucciones página 86

English
Fault Light strips on
the robot
mower or
docking station
The robot mower Illuminated
fails to start the strips light up
mowing process blue.
as expected.
Light strips light
up red.
The LED on the
docking station
lights up red.
The robot mower Light strips light
is not charging. up red.
The LED on the
docking station
lights up red.
23 Specifications
23.1 STIHL iMOW 5.0, 6.0, 7.0
Robot Mower
Specifications
– Cutting width: 28 cm
– Cutting height - electric: 20 mm to 60 mm
– Speed of the blade disk: 2400 rpm
– Mowing speed
– iMOW 5.0: 0.45 m/s
– iMOW 6.0: 0.45 m/s
– iMOW 7.0: 0.45 m/s
– Dimensions:
– Width: 291 cm
– Height: 525 cm
– Length: 705 cm
– Weight:
– iMOW 5.0: 14 kg
– iMOW 6.0: 15 kg
– iMOW 7.0: 15 kg
– Protection class: III
– Degree of protection: IP56
– Maximum mowing surface:
– iMOW 5.0: 1500 m²
– iMOW 6.0: 3000 m²
2
Under ideal conditions (few obstacles, simple geometry and low gradients in garden, moderate
growth of lawn)
86
Cause
The robot mower is
restarting.
There is a fault on the
perimeter wire or
guide wire.
There is a fault in the
robot mower, battery,
power supply or
docking station.
– iMOW 7.0: 5000 m²
– Active time 1000 m² (per week)
– iMOW 5.0: 50 h
– iMOW 6.0: 35 h
– iMOW 7.0: 30 h
– Maximum length of the perimeter wire: 850 m
– Maximum gradient: 40%
Bluetooth
– Data connection: Bluetooth
appliance must be compatible with Bluetooth
Low Energy 5.0 and support Generic Access
Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can vary
greatly depending on local conditions, includ‐
ing the receiver. The range may be perceptibly
reduced inside enclosed rooms and through
metal barriers (such as walls, shelves or
cases).
– Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
Remedy
► Wait until the restart has been comple‐
ted.
The robot mower then automatically
starts the mowing process.
► Make sure that the perimeter wire or
guide wire is undamaged.
► Make sure that the perimeter wire or
guide wire is correctly connected to the
docking station.
► Make sure that the perimeter wire and
guide wire are correctly connected to the
wire connector.
► Follow the instructions in the MYiMOW
app.
► Make sure that the charging contacts on
the docking station and robot mower are
clean.
► Follow the instructions in the MYiMOW
app.
► If the fault persists: Do not attempt to fur‐
ther charge the robot mower, remove the
mains plug of the connecting cable from
the socket outlet and contact a STIHL
authorized dealer.
®
23 Specifications
®
®
2
®
5.1. The mobile
®
0458-011-9801-A