Publicidad
Idiomas disponibles
Idiomas disponibles
21 Repairing
21 Repairing
21.1
Repairing the robot mower,
battery, blades, docking station
and power supply
Users cannot repair the robot mower, battery,
docking station and power supply themselves.
Damaged or worn blades can be replaced.
► If the robot mower, battery, docking station,
charging cable, power supply or connecting
cable is damaged: Do not use the robot
mower, battery, docking station, charging
cable, power supply or connecting cable and
contact a STIHL authorized dealer.
► If a blade is damaged or worn:
► Stop the robot mower and activate the
device lock.
► Replace all blades. The blades cannot be
re-sharpened.
► If warning labels are illegible or damaged:
Have the warning labels replaced by a STIHL
authorized dealer.
21.2
Extending or repairing perime‐
ter wire or guide wire
The perimeter wire or guide wire can be exten‐
ded or repaired using wire connectors.
Wire connectors are filled with gel to prevent pre‐
mature wear or corrosion of the wire ends.
22 Troubleshooting
22.1
Troubleshooting the Robot Mower
Most faults are indicated in the MYiMOW
docking station.
Proceed as follows for troubleshooting:
► Follow the instructions in the MYiMOW
or
► Press the INFO pushbutton on the control panel and follow the audible instructions.
Fault
Light strips on
the robot
mower or
docking station
The robot mower
stops on the way
back to the
docking station.
0458-011-9801-A
► Make sure that the overall length of the perim‐
eter wires does not exceed the maximum
length of 850 m.
1
► Insert the wire ends (2) into the wire connec‐
tors (1).
Do not strip the wire ends.
► Press the wire connector (1) together up to the
limit stop with a pair of pliers.
► Route perimeter wires at least for a length
a = 5 cm parallel and close together without
the perimeter wires crossing.
®
app and by red light patterns on the robot mower or
®
app.
Cause
The battery is dischar‐
ged.
2
Remedy
► Make sure that the length of the perime‐
ter wire does not exceed 850 m.
► Optimize routing of the guide wire.
► Install another guide wire within the
mowing area.
► Carry the robot mower to the docking
station for charging.
► If possible, in a mowing area with a
slope, position the docking station in the
lower area of the slope.
English
a
85
Publicidad
