Storage, Transportation, and Mounting
Hex Wrench Storage
(Fig. 33)
When not in use, store the Hex Wrench 33 on the
rear right foot of the table saw's Base 5.
To store the Hex Wrench:
1. Slide the short end of the Hex Wrench 33
into the Hex Wrench Storage Port 67 provid-
ed on the rear right foot of the saw
2. Rotate the Hex Wrench 33 counterclockwise,
and push until the long end of the Wrench 33
snaps into the Hex Wrench Storage Bracket
68
.
Fig. 33
B
68
1609B07947GTS18V-08 OSI 08-2022.indd 30
Blade Wrench Storage
(Fig. 34)
When not in use, store the Blade Wrench 27 on
the Blade Wrench Bracket 69 provided on the
front right side of the saw, directly under the
Table 13.
To store the Blade Wrench:
.
1. Line up the Mounting Hole on the Blade
2. To secure the Blade Wrench 27 in place,
33
To remove the Blade Wrench 27:
1. On the on the Blade Wrench Bracket 69,
2. Slide the Blade Wrench 27 off the Threaded
A
67
Fig. 34
-30-
Wrench 70 with the Threaded Rod 71 on
the Blade Wrench Bracket 69, and slide the
Blade Wrench 27 onto the Threaded Rod 71
until the Blade Wrench 70 nests in the Blade
Wrench Bracket 69
.
install the Wingnut 72 provided onto the
Threaded Rod 71
, and tighten.
loosen the Wingnut 72 securing the Blade
Wrench 27 on the Threaded Rod 71.
Rod 71, and reinstall the Wingnut 72.
71
A
69
69
70
70
72
B
27
27
8/3/22 2:44 PM