Publicidad
Idiomas disponibles
Idiomas disponibles
3. For rabbeting across an end, for a workpiece
that's 10-1/2" (267 mm) or narrower:
• Make the rabbet cut with the board flat
on the Table 13.
• Using the Miter Gauge 14 fitted with a
facing, follow the same procedures and
instructions for crosscutting, making
suc cessive cuts across the width of the
workpiece to obtain the desired width of
cut. DO NOT use the Rip Fence 9 for rab-
beting across the end.
4. INSTALL SMART GUARD SYSTEM 11 IMME-
DIATELY UPON COMPLETION OF RABBET-
ING OPERATION.
Rabbet cuts can also be made in one pass of the
workpiece over the cutter using the dado head.
Fig. 89
first cut
rabbet
second cut
rabbeting
along the
edge
Fig. 90
104
13
1609B07947GTS18V-08 OSI 08-2022.indd 56
Basic Table Saw Operations
rabbeting
across the
end
9
32
-56-
Dado Cutting
Instructions for operating the saw with dado
sets are contained in the booklet furnished with
these accessories.
ALWAYS USE AN APPROPRIATE BOSCH TABLE
INSERT 12 LISTED UNDER "Attachments and Ac-
cessories." (See page 61).
Installing a Dado Set
To reduce the risk of injury,
always disconnect the Bat-
tery Pack before changing Blades.
To reduce the risk of injury,
always use the Bosch Dado
Blade Table Insert No. TS0801. Never make
dado cuts without this insert. Never set dado
cutters to any bevel angle other than the vertical
0° angle. Follow all warnings and instructions
shown here and those that accompany your
dado set. Failure to comply with these warnings
may result in serious bodily injuries.
To reduce the risk of injury,
do not use dado sets larger
than 6" (152.4 mm) in diameter. The saw is not
designed to accept larger sized dados.
A dado set is an accessory system used to make
non-through grooves or lap cuts on work pieces.
These tools are commonly used in furniture and
cabinet building. After work pieces have been
properly dado cut, they can be tightly joined to-
gether. This table saw can accommodate dado
cutting up to 1/2" (12.7 mm) wide in a single
pass.
8/3/22 2:44 PM
Publicidad
