Publicidad
Idiomas disponibles
Idiomas disponibles
Heating
8.4
Heating control panel
The heater is controlled with a dedicated control panel (Truma CP plus). It is located next to the control
panel.
Symbol for
hot water menu
Symbol for
heating menu
Time indicator
Settings/values
Return button
Different values and parameters can be selected, changed and stored with the turn/push button.
The selected menu items will flash.
8.5
Operating the heating system
Turn the turn/push button to the right to scroll through the symbols of the upper menu until the heating
symbol appears.
Press the button to confirm the selection. Turn the button to the right again to select the desired
temperature.
8.6
Operating the heating with hot water supply
Turn the turn/push button to the right to scroll through the symbols of the upper menu until the heating
symbol appears.
Press the button to confirm the selection, then select the hot water symbol and press the button again to
confirm the selection.
8.7
Faults
In the event of a fault, the Truma CP+ controller immediately switches to the "Fault" menu and shows the
error code of the fault. Refer to the manual for the Truma CP+ controller for information about
troubleshooting and instructions for eliminating faults.
After the problem has been identified and corrected, reset the system by pressing and holding the
turn/push button for at least four seconds to switch off the unit. Then turn the unit on again.
EN 62
Control panel for Truma CP plus
Symbol for energy
selection menu
Status line
Menu cell (top)
Display of 230 V
mains voltage
(mains power)
Menu cell (bottom)
Turn/push button
Publicidad
