Menu Settings - OHAUS Scout SJX Serie Manual De Instrucciones

TM
SCOUT SJX SERIES BALANCES
Start
If no weight value is held on the display, press Function key to begin. The [r r EAdY] (Ready) will
be displayed until a weight is added on the pan.
When the stable value is being held on the display, the Hold icon (H) will blink and the displayed
weight will not change.
Reset
If the pan is empty and a weight value was held on the display, a single short press of the
Function key will clear the held value and show the new weight on the pan.
1. Press and hold Mode until [HoLd] is displayed.
2. If required, place an empty container on the pan and press Tare. Zero value will then
display.
3. Press Function key to begin. The [rEAdY] (Ready) will be displayed.
4. Place samples to be weighed on the pan.
5. The stable value will be held on the display, the Hold icon (H) will blink.

4. MENU SETTINGS

The User Menu allows the customizing of balance settings.
Note: Additional Sub-Menus may be available if Interface Options are installed. See Interface
User Manual for the additional setting information.
4.1 Menu Navigation
User Menu:
Sub-Menus
User Menu Items:
Long press -
Enter menu
Short press -
Yes
Accept
No/Back B B B B B B B B B B B B B B B B B B B B B B B a a a a a a a a a a a ac a a a a k
Short press –
Go Next/Prev.
menu
Exit
Short press –
Exit menu
Note:
* These sub-menus are not available in SJX/E models.
** Available Units may vary by local regulations.
*** Available settings may vary by local regulations.
When the Security Switch is in locked position, see figure below, the menu settings are affected
as follows:
External calibration function is hidden.
The readability will be reduced by a factor of 10 or brackets will be displayed around the
last digit, depending on the model.
The Auxiliary Graduation menu will be locked when the security switch is in locked position.
Units are locked to the current setting.
Stable range locked to 1d
Find Quality Products Online at:
C.a.l S.E.t.U.P
In.CAL* Reset
Yes/No
CAL.Adj* Auxiliary
-100
Graduation***
..
On/Off
0
Filter
..
100 Low/Med/High
Span
AZT
0.5/1/3/Off
Lin
StableRange
0.5/1/2//5
Backlight
Off/On/Auto
Auto Tare
Off/On/On-acc
Auto Off
Off/1/5/10
End End
GlobalTestSupply
www.
M.o.d.E U.n.i.t**
Reset Reset
Yes/No g
kg
Weighing
ct
On/Off
oz
Counting
ozt
On/Off
dwt
Percent
lb
On/Off
grn
Check
hkt
On/Off
sgt
Totalize
twt
On/Off
t
Density
tola/tical
On/Off
Hold
Disp/Peak/Off
End End
.com
EN-9
E.n.d
sales@GlobalTestSupply.com