Amprobe SOLAR-600 Manual De Uso página 16

3. Press button to start MANUAL SCAN. After the scanning is
finished, the result will come out like below.
If users are interested in a specific point of test current, users can enter
the current value for a Single Test Point. Press TEST (
characteristics at the current.
1. Press button to turn on the Analyzer. Properly connect the pair of
Kelvin clips to the solar panel and the Analyzer. The red Kelvin clip is for
positive pole and the black Kelvin clip for negative pole.
2. Press button to enter the SETUP menu: (Type in the testing current)
Single Test Point: 609mA
After setting up the current range, press
SETUP menu.
3. Press button to start Testing a Single Test. After the testing is
finished, theresult will come out like below. The result (P, V, I) is shown in
reverse video as below.
button again to exit the
9
) to test the