Amprobe SOLAR-600 Manual De Uso página 24

(1) Time delay before scan.
This delay allows light source to illuminate the solar panel
before scan stars.
(2) Sampling time of data logging (0 to 99 minutes)
(3) Current Range of Scan begin.
The beginning value of current for scan to start.
(4) Current Range of Scan end.
The ending value of current for scan to stop.
(5) Area of Solar Cell or Panel.
Based upon the input area and irradiance, this unit can
calculate the solar power converting efficiency
(6) Irradiance.
Light intensity in W/m2.
(7) Single Test Point.
Users can enter a specific value of current here. When users
press the TEST button, this specific value of current will be
simulated and result will be shown.
(8) Alarm of Low Power.
If the maximum power is lower than this value, then a beep sound will
be heard.
3. Press or
Press or
few seconds to promptly change setting values.
4. After setting Parameters, press
buttons to select the setting items.
buttons to change the setting values, or press them for
button to exit SETUP menu.
17