Bresser Thermo Hygro Quadro NLX Manual De Instrucciones página 11

3 Display of seconds or sym-
bol for the alarm time (de-
pending on the selected
mode)
5 Temperature indoors (in °C
or °F)
7 Symbol for the humidity
9 Temperature outdoors (in °C
or °F) (remote sensor 1)
11 Humidity outdoors (in %)
(remote sensor 1)
13 Outdoor temperature (in °C
or °F) (remote sensor 2)
15 Temperature outdoors (in
°C or °F) (remote sensor 3)
17 Weather trend symbol (bet-
ter, steady, worse)
7 Before commissioning
NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices,
the following points must be observed during commission-
ing.
1. Place the base unit (receiver) and sensor (transmitter)
as close together as possible.
2. Connect the power supply to the base unit and wait un-
til the indoor temperature is displayed.
3. Establish power supply for the sensor.
4. Set up/operate the base unit and sensor within the ef-
fective transmission range.
5. Make sure that the base unit and the radio sensor are
set to the same channel.
4 Trend symbol (decreasing,
constant or increasing)
6 Symbol for the temperature
8 Indoor humidity (in %)
10 Symbol for the sensor con-
nection status
12 Trend symbol (decreasing,
constant or increasing)
14 Humidity outdoors (in %)
(remote sensor 2)
16 Humidity outdoors (in %)
(remote sensor 3)
18 Weather forecast graphics
(12 hours)
11 / 80