Sagola MINI xtreme mix Manual De Instrucciones página 24

Mix, prepare and filter the product to be applied in accordance with the
manufacturer's instructions, ensuring that any foreign bodies are prevented
from spoiling the quality of finish and application. Should there be any doubt
relating to the purity of the product, its composition, etc., please contact your
supplier.
Control the viscosity of the product to be applied with the SAGOLA
Viscosimeter - Código 56418001
07. Useful tips
7.1.- General advice
You are recommended to use the gun with the product regulator open (without removing it
completely from its housing) in order to minimise wear to the fluid tip and needle and to ensure
maximum amplitude.
Use the lowest spray pressure in the nozzle that allows you to obtain the required
finish. Not all products require the maximum pressure for correct spraying. With
a lower pressure, less air is consumed and there is an additional increase in
product transfer.
The gun leaves the factory ready to spray products correctly with the air nozzle
corresponding to each application. It is adjusted to an air inlet pressure of 2 bar
to ensure maximum performance.
Pay special attention to the application speed. The thickness of the film deposited may be
greater than planned if the application speed is low, and the opposite is also true..
If the thickness of the layer is very thin, this is due to the fact that the air pressure is excessive
for the amount of product being applied. Reduce the air pressure in the gun in order to ensure
that the solvent in the paint does not evaporate during spraying and that this is not dry when it
reaches the surface to be painted. Increase the amount of product, correct its viscosity or use
a larger fluid tip in the gun.
If the film is thick, this is due to the fact that the air pressure is excessive for the amount of
product to be applied. Decrease the amount of product, reduce its viscosity or use a smaller
fluid tip in the gun.
If sagging occurs, this is due to the fact that the amount of product to be applied is excessive for
the air pressure used, that the viscosity is not correct or the application speed is not adequate.
Decrease the amount of product, adjust its viscosity or increase the application speed until the
required finish is obtained.
The spraying width (spraying pattern) obtained will depend on the air nozzle used. If nozzles
are required for other applications, contact the Technical Service of SAGOLA S.A.U. Apply the
product perpendicularly to the part.
ENGLISH
Ford
Nº4