Publicidad
Idiomas disponibles
Idiomas disponibles
28/29
• Gun head packing gland: In order to replace the packing gland, remove the spring cap (No.18)
and extract the product needle and spring (No.17). With a 21 mm fixed wrench (No.25), remove
the nozzle to be replaced. Remove the safety ring (No.6) and push the packing gland (No.5) to
remove the housing nozzle. Apply lubricant grease. Replace the packing gland and reassemble
in the reverse order.
• Packing gland of the air valve: In order to replace the packing gland, remove the spring cap
(No.18) and extract the product needle and spring With a 9 mm Allen wrench, remove the guide
box, extracting the valve spring, the valve and the seat valve (No.22) with key (No.24). With a 6
mm Allen wrench, remove the packing gland and extract the gasket. Replace the packing gland
and the gasket (supplied in the specific kit) and follow the reverse procedure.
11.2. Cleaning or replacement of the product filter
If there is any cleaning liquid or product, return it to its corresponding containers. To avoid any
spillage, keep the pistol in a vertical position and clean as thoroughly as possible.
· Holding the gun firmly by the handle, disassemble the hose by unscrewing
it from the body of the gun.
· Extract the product filter and if there is any cleaning liquid or product
remaining in the body of the pistol, return it to its corresponding container.
· Clean or replace the product filter as needed, taking into account that the
impurities will cause defects in the finish and/or obstructions.
· Assemble the product filter again, inserting it all the way into the hole in
the input rotating fitting.
· Check there are no leaks.
11.3. Assembly lip seal in aircap
01
02
1.- Remove the
2.- Place the
TIP from the
washer inside the
aircap
aircap
05
06
5.- Lip seal
6.- Tighten the
placed inside the
aircap tightly until
aircap
the lip seal is
inserted into the
nozzle
03
Plain washer
Ø10.5 DIN433
3.- Washer placed
inside the aircap
07
08
7.- Threaded
8.- Remove the
aircap in the
aircap
spray gun
ENGLISH
04
4.- Place the lip seal
in the indicated
position
09
9.- Finish
manually
inserting the lip
seal into the slot
nozzle
Publicidad
