VITO Pro Power VIBEP Manual De Instrucciones página 30

The appliance has been developed to screw drywall.
When operating the drywall screwdriver, you must consider
some use procedures:
▪ Do
not apply excessive
workpiece/object. If the speed drops abruptly, reduce
the pressure applied to the drywall screwdriver
immediately;
▪ Never put the tool down before the bit has completely
stopped;
▪ Wear hearing protection when using the screwdriver.
Exposure to noise can cause hearing loss;
▪ Work in such a way that the power cord always remains
behind the drywall screwdriver during operation;
▪ Switch off the drywall screwdriver immediately if any of
the following problems occur:
- Sparks at the carbon brushes and smoke formation;
- Grease leakage through the ventilation slots;
- Damage to the drywall screwdriver housing;
- Damage to the "ON/OFF" switch";
- If you sense smoke or burning smell.
pressure against the
1. Before connecting the power cord (7), make sure the
ON/OFF switch (8) is off;
2. Hold the screwdriver with both hands;
3. Place the screwdriver against the surface to be screwed
and press the "ON/OFF" switch";
4. Use the screwdriving depth stop (2) to set when the
screwdriver must stop;
5. To switch off the screwdriver, release the "ON/OFF"
switch trigger";
To operate the drywall screwdriver continuously:
6. Press the "ON/OFF" switch and simultaneously press the
switch lock-on button (5). Release the buttons and
operate the screwdriver with the "ON/OFF" switch locked;
7. To switch off the screwdriver, press the "ON/OFF" switch
and release it.
Do not select the direction of rotation while the screwdriver
is running. This could cause serious damage to the
screwdriver. Always check the direction of rotation before
starting operation.
1. Use the forward/reverse lever (10) to select the direction
of rotation of the shaft:
▪ With the lever on the left, the shaft turns clockwise;
▪ With the lever on the right, the shaft turns
counterclockwise.
The rotation speed can be adjusted using the "ON/OFF"
switch. The rotation speed increases as you press the
"ON/OFF" button".
You can also adjust the speed by means of the speed
control (9).
1. To increase the speed, turn the regulator clockwise;
2. To decrease the
counterclockwise.
Do not run the screwdriver at low speed for a long period of
time.
speed, turn the regulator