Dräger X-plore 8000 Helmet Serie Instrucciones De Uso página 18

en |
Maintenance
®
1. Take off the Dräger X-plore 8000 helmet with visor where the ambient air is
no longer contaminated.
®
2. Clean the Dräger X-plore 8000 helmet with visor (see chapter 4.1).
5 Maintenance
5.1 Cleaning and disinfecting
CAUTION
Potential damage to component parts!
► For cleaning and disinfecting only apply the described procedures and use
the specified cleaning agents and disinfectants. Other agents and
procedures, dosages and exposure times can damage component parts.
CAUTION
Health hazard!
The undiluted agents are damaging to health if they come into direct contact
with the eyes or skin.
► Wear goggles and protective gloves when working with these agents.
For information on suitable cleaning agents and disinfec-
tants and their specifications, see document 9100081 at
www.draeger.com/IFU.
1. Prepare a cleaning solution containing water and a cleaning agent.
2. Clean all parts with the cleaning solution using a soft cloth. Make sure the
visor does not get scratched.
3. Thoroughly rinse all parts under running water.
4. If the sweatband needs disinfecting:
a. Prepare a disinfectant bath of water and a disinfecting agent.
b. Put the sweatband into the disinfectant bath.
c. Rinse the sweatband thoroughly under running water.
5. Allow all parts to air-dry or dry them in the drying cabinet (temperature: max.
60 °C). Keep away from direct sunlight.
18
5.2 Maintenance work
5.2.1 Checking serviceability
1. Check the helmet shell, internal helmet components, visor and accessories
for cracks, deformations or other damage, as well as wear. Check also that
the helmet fits correctly.
2. Replace scratched or damaged parts.
WARNING
The protective effect is reduced after impact!
If the helmet absorbs the energy of an impact, it may be damaged or destroyed.
► Even if the damage is not visible at first, the helmet must be replaced after a
heavy bump or impact.
► Damaged or impact-stressed helmets must no longer be used. This also
applies if no external damage is visible.
WARNING
Reduced visibility or limited protective effect by scratched or damaged visors!
► Replace scratched or damaged visors.
5.2.2 Replacing the face cuff
1. Release the hook-and-loop fasteners on the face cuff from the support ring.
2. Remove the visor from the adapters and pull the face cuff from the visor.
3. Position the face cuff bottom centre on the visor. Ensure that the tabs are on
the outside. Fully attach the Velcro strap to the visor.
4. Insert the visor bracket through the loops in the face cuff and place the loops
around the joints on the visor bracket.
5. Insert the visor bracket as far into the adapters on the helmet as possible.
6. Place the Velcro tabs on the rubber strap around the support ring (from
inside to outside) and fasten them so that the face cuff lies tightly against the
user's face.
5.2.3 Replacing the visor
Illustration on the fold-out page (figure C)
1. Pull both sides of the visor out of the visor bracket.
2. Release the expanding rivet until the visor can be removed.
Instructions for use |
Dräger X-plore 8000
®
Helmet with Visor