Bowers & Wilkins CDA-4D Manual De Instrucciones página 13

7.2.1 Input Source Setup
Input Level Meter
This displays the input signal sent to the amplifier.
Input Source
Select input source from the following selection
Analogue / Digital / AVB*
*AVB is available when two or more Bowers & Wilkins CDA
amplifiers (CDA-2HD or CDA-4D) are connected to the same
wired network using AVB enabled network hardware (AVB
enabled switch). Analogue or digital input sources from other
CDA amplifiers can be selected as an input source.
AVB Input Sources
AVB input sources will be available when sibling
devices are able to recognise each other on the
network. The sibling device will be shown in the
INPUT SOURCE drop down with the serial number
or friendly name of the device shown in the list.
You will be able to select either of the inputs
from that device to use.
Input Name
All available input channels are listed in this section.
Each input name can be customised to describe the
type of input connected. Changes made to the Input
Name will be reflected through the settings page.
Trim Level
Trim level can be adjusted for each channel from
-11dB to +13dB with a 1dB of increments.
The trim level allows levelling of the inputs before
being amplified. The total system gain will be
calculated and shown when trim level is adjusted.
13