2.2 Foot mounting
CDA-4D can also be table mounted and is supplied
with feet and feet screws, see Diagram 3.
Ensure that, once positioned, the amplifier is well
ventilated and that the ventilation apertures are not
obstructed. If the system is taken out of use for a
long period, disconnect the amplifier from the mains
power supply.
To prevent damage, maintain adequate
ventilation space to the sides of the amplifier.
CDA-4D can be stacked vertically but
be sure not to place the amplifier next to other
components, or against the side of a cabinet.
Doing so will block ventilation openings.
3. Controls and Connections
Rear panel sockets and switches,
see Diagram 4.
1. Power input socket (IEC C14)
2. Output
3. Reset button
4. Ethernet (RJ45) socket
5. 12V trigger in / out
6. Digital inputs
7. Analogue inputs
Front panel controls, see Diagram 5.
1. Power LED
2. Ethernet LED
3. Zone status LEDs
3.1 Reset Button
Using the factory reset can erase all setting
and revert the amplifier back to the factory
flashed firmware.
Reboot
This allows the device to gracefully
shut down and restart.
a. Single press of the reset button -
The LED will flash green while rebooting
Reset
This will reset all settings and all saved presets.
a. Press and hold the reset button for
5 seconds until the LED starts flashing green.
b. Release the button and wait for
the device to restart.
Note: Reboot and Reset can also be achieved
via the Product Configuration Page, see section
7.1.6 Settings Management
Factory Reset
This will reset all settings, all saved presets and
device firmware to its original factory settings.
a. Make sure the unit is turned off using
the AC power inlet switch.
b. Press and hold the reset button and turn the
AC power inlet switch on – keep pressed for 10
seconds until the LED starts flashing green.
c. Release the reset button and wait for
the device to restart.
Diagram 3. Foot mounting
4x
g
e
f
b
c
d
4x
Diagram 4. Rear panel
1.
Diagram 5. Front panel
2.
3.
4.
1.
5.
6.
7.
2.
3.
5