Bowers & Wilkins CDA-4D Manual De Instrucciones página 21

10. Specifications
Audio Specifications
Load impedance range:
Output Power per channel, non-clipped:
Output Power bridge mode, non-clipped:
Output Power total, all channels:
DC offset voltage:
Frequency Response (-3dB):
Frequency response accuracy 20Hz-20kHz:
Dynamic range:
THD+N (1kHz, 500W, 4Ω):
Voltage Gain:
Input impedance:
Maximum input voltage:
Signal sense threshold:
Wake-up time:
Turn-off time:
12V trigger input threshold:
Controls & Indicators
Front panel:
Rear panel:
Connectors
Input:
Output:
12V trigger control:
Power
Power consumption:
AC supply:
AC inlet:
Thermal
Thermal dissipation:
Dimensions
Height:
Width:
Depth:
Net weight:
Finish:
>3Ω per channel (>6Ω in bridge mode)
60W into 8Ω
125W into 4Ω
250W into 8Ω
500W short term
>125W continuous
<50mV
<10Hz to >30kHz, any load impedance
+/-1dB
>85dB A-Weighted
less than 1%
15dB to 39dB, adjustable
10KΩ
4 Vrms
2.5mV (independent of Gain setting)
<0.2s (If other zones active)
<2s (From all zones inactive)
15 minutes from last signal detected
typically 3V (recommended input is 5-15V)
1 x Power LED (Unit active – White, Fault – Red)
1 x Network status LEDs (Network present – White, Fault – Red)
2 x Zone status LEDs (Signal present – White, Fault – Red)
Reset button
2 x RCA (pair) Phono socket, Analogue line in
2 x RCA Phono socket, Digital line in
1 x Ethernet
2 x 5.08mm Pitch 4-way Phoenix Combicon style
1 x 3.5 mm jack - 12V trigger IN
1 x 3.5 mm jack - 12V trigger OUT (Maximum 100mA pass-through)
<0.5W Standby, WoL disabled
<0.5W Standby, WoL enabled
130W maximum average
1,600W peak
100-240V 50/60Hz
IEC C14, switched
1.7 BTU/hr (standby),
130 BTU/hr (Idle),
500 BTU/hr (max)
42.5 mm (1.7 in) 1U [55.5mm (2.2in) plus feet]
437 mm (17.2 in)
310 mm (12.2 in)
4.1kg (9.0lb)
Black
21