Bowers & Wilkins CDA-4D Manual De Instrucciones página 15

7.2.3 Output Setup
Output Level Meter
This monitors the audio output level sent
to the speakers.
Output Name
This section list all available output channels. Each
output name can be customised to describe the type
of output connected. Changes made to the Output
Name will be reflected through the settings page.
Speaker
Select the product model for each channel that are
used with the CDA-4D. When using a non-Bowers &
Wilkins product, please choose any User Preset.
Stereo / Mono
Allows each channel to be set for Stereo or Mono
operation. When Mono is selected the Left and
Right of the input selected will be combined to
create Mono.
Amplifier Mode
When more power is required, two channels can
be bridged into one channel. See 4.2 Connecting
to speakers on how to connect a Bridge-Tied
Load product.
7.2.4 Zone
Zone
CDA-4D has 2 output zone, Zone 1 or Zone 2.
This groups the settings Output Volume, Turn On
Volume and Mute across channels which have
the same Zone.
Control System Drivers for Zones
If using this device on a single zone driver
with a control system, please make sure
zone 1 is selected on all outputs or the control
system will not recognise the device.
7.2.5 Output Source Priority
Source 1
This is the primary source you will direct to the
speakers. Left inputs default to left outputs and right
inputs to right outputs.
Source 2
This is used as a secondary input source
Priority
CDA-4D has two available Input Source. This allows
the user to define which input source to be used.
Source 1 only - Only play from Input Source 1.
Source 2 priority – Input Source 2 will have priority
over Input Source 1, while Source 1 will mute.
Mix – Input Source 1 and Input Source 2 will be
blended together when a signal is present on Input
Source 2.
7.2.6 Output Volume
This is the main volume level control for each
channel. When channels are placed in the same
output group the levels will change simultaneously.
Output Volume
Main volume level control for each channel. When
channels are placed in the same Output Zone the
levels will change simultaneously.
Turn On Volume
In case of power outage, the TURN ON VOLUME
ensures system always comes back on at the same
level. When channels are placed in the same Output
Zone the levels will change simultaneously.
Maximum Volume
Where high volume level is not required. Turn On
Volume and Output Volume will be capped at Max
Volume. This is an independent setting not affected
by the Output Zone.
Mute
Eliminates the output from the speakers.
Channels placed in the same Output Zone
will change simultaneously.
15