Publicidad
Idiomas disponibles
Idiomas disponibles
Exterior cleaning
•
To maintain good appearance of your appliance, you should clean it regularly.
•
Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance. This helps
ensure an even distribution of moisture to the surface.
•
Clean the doors, handles and cabinet surfaces with a mild detergent and then wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are likely to scratch the surface. Don't use Thinner, Car detergent, Clorox,
ethereal oil, abrasive cleansers or organic solvent such as Benzene for cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low. Wipe the
inside of the fridge freezer with a weak solution of bicarbonate of soda, and then rinse with warm water using
a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves and baskets. Thoroughly dry all
surfaces and removable parts.
Only wipe the lamp switch, lamp and other electrical element with dry cloth.
Door seals cleaning
Take care to keep door seals clean. Clean the door seals with damp cloth and dry it thoroughly.
Caution! Only after the door seals are completely dry should the appliance be powered on.
Replacing the light bulb (replacement shall be taken by a professional)
1)
Before carrying out the bulb replacement always press and turn the thermostat control to position "OFF",
then disconnecting the mains supply.
2)
Hold and lift up the light bulb cover.
3)
Remove the old bulb by unscrewing it in an anti-clockwise direction.
4)
Replace with a new bulb (Max.10W) by screwing it in a clockwise direction marking sure that it is secure in
the bulb holder.
5)
Refit the light cover and re-connect your appliance to the mains supply and switch on.
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length of time during this process, it must be allowed to
remain upright for 6 hours before plugging it in to avoid damage to the internal components.
1. Remove the hinge cover and upper hinge from the top right side of the cabinet. Remove the screw hole
cover from the top left side of the cabinet.
2. Remove the refrigerator door from the cabinet. Move the hinge plug from the top left to the top right side
of the door.
3. Remove the center hinge from the right side of the cabinet. Remove the screw hole covers from the left side
of the cabinet.
- 11 -
Publicidad
