Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting compactor roller scraper
The scraper is used to clean the compactor roller, remov-
ing any soil and debris that has built up.
Carry out the operations described.
1) Loosen the screws (A).
2) Position the scraper (B) so that it is slightly touching
the compactor roller.
3) Tighten the screws (A).
Adjusting ploughshare depth
The work depth is reached either using the tractor's lift
or by adjusting the wheels with the cutting discs.
The ploughshare is used to keep the chosen working
depth constant, especially on when working on com-
pact ground.
For ploughshare adjustments, proceed as outlined be-
low.
Carry out the operations described.
1) Loosen the screws (A).
2) Position the ploughshare (B) as required for the work
to be performed.
3) Tighten the screws (A).
4) Perform the same steps to adjust the ploughshare on
the other side.
Adjusting transmission chain tension
NOTICE
Do not overtighten the chain as this could cause pre-
mature wear of the chain and the sprockets.
Carry out the operations described.
1) Loosen the screws (A).
2) Unscrew the screw (B).
3) Remove the fixed casing (C).
English language
ADJUSTMENT INFORMATION
UN41-0821LR
UN41-0822LR
4) Loosen the sprocket (D).
5) Adjust the sprocket until you reach the sag value (F)
shown in the figure.
6) Tighten the sprocket (D).
7) Position the fixed casing (C).
8) Tighten the screw (B).
9) Tighten the screws (A).
12
5
B
A
A
B
Use and maintenance
Publicidad
