Publicidad
Idiomas disponibles
Idiomas disponibles
INITIALIZING THE INTERFACE
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Refer to step 2 of "Installing the interface".
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type; "Ford F-150".
b. Wait until the radio comes on, and the touchscreen display shows "SWC Configured*". This
process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within 3
minutes, and/or the touchscreen display does not show "SWC Configured*", turn the vehicle
off and disconnect the 5838 harnesses from port "A" in the touchscreen display. Check all the
connections, reconnect the harness into the touchscreen display, and then try again.
* For models with steering wheel controls.
4. Test all functions of the installation for proper operation, before reassembling the dash.
10
FINAL ASSEMBLY
1. Secure the completed assembly into the upper dash using the factory hardware removed in
step 5 of dash disassembly.
2. Snap the radio trim panel with touchscreen display over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
|
1.800.221.0932
MetraOnline.com
Publicidad
