Publicidad
Idiomas disponibles
Idiomas disponibles
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end
of its technical life, discard it with due care for our environment:
Type B
(shallow, Grinding)
Type A (Type 41) guards are intended for use with Type 41 (1A) cutting wheels and Type 42 (27A) wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper guard
possible that does not contact the accessory.
nOTE: Type A (cut-off) and Type B (grinding) wheel guards where previously referred to as Type 1/41 and Type 27 wheel guards.
additional Information for Guards and accessories for DCG409Vs, DCG416Vs
When using segmented diamond wheels, use only
diamond wheels with a peripheral gap not greater than
10 mm and negative rake angle.
DO NOT USE
segmented diamond wheels with a peripheral gap greater
than 10 mm and/or a a positive rake angle.
For all grinding, sanding, and wheel type wire brushing
accessories, the lowest portion of the accessory must
be contained within the guard enclosure with 2mm or
greater clearance to the bottom lip of guard
•
•
Guard Types for DCG409Vs, DCG416Vs
Type a
(Closed cut off)
Run the battery pack down completely, then remove it from
the tool.
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Type E
(Diamond surface grinding wheel
guard))
≤10 mm
EnGLIsh
≥2 mm
59
Publicidad
