Bosch SCT 815 S3 Manual Original página 10

en | 10 | SCT 815 S3
 WARNING – severe eye damage from laser beam.
7. Never look directly into the laser source.
8. To test function, hold an object in front of the exit
point of the laser range finder.
9. Switch on the laser range finder.
 CAUTION – risk of crushing when adjusting the
height of the prismatic reflector.
10. Do not place fingers between the tool holder and
the guide tubes.
11. Loosen the knurled screw
til the height of the prismatic reflector can be adjus‐
ted.
3
2
1
(1) Knurled screw
(2) Laser beam
(3) Laser point on manufacturer's badge
12. Adjust the height of the tool holder in such a way
that the red laser point is directed at the manufac‐
turer's badge or front radar sensor, depending on
the specification in the brief instructions.
13. Use the knurled screw to secure the tool holder.
---
4.6 Setting the offset (up to 25 cm) from
the vehicle's longitudinal center plane
---
SCT 815 S3 must be aligned with the vehicle's longitu‐
dinal center plane.
---
The offset of the prismatic reflector from the vehicle's
longitudinal center plane is specified in the corre‐
sponding brief instructions. The offset specific to the
vehicle is found in the column with the following picto‐
gram.
---
1. Use the corresponding brief instructions.
2. Look up the offset of SCT 815 S3 for the relevant ve‐
hicle.
3. Use the ruler on the tool holder
of the prismatic reflector.
1 689 989 477 | 2020-05-01
(1)
on the tool holder un‐
(1)
to set the offset
2
(1) Ruler on tool holder
(2) Arrow on prismatic reflector for precise offset setting
---
4.7 Setting the offset (25 cm and above)
from the vehicle's longitudinal center
plane
---
SCT 815 S3 must be aligned with the vehicle's longitu‐
dinal center plane.
---
The offset of the prismatic reflector from the vehicle's
longitudinal center plane is specified in the corre‐
sponding brief instructions. The offset specific to the
vehicle is found in the column with the following picto‐
gram.
---
1. Use the corresponding brief instructions.
2. Look up the offset of SCT 815 S3 for the relevant ve‐
hicle.
 WARNING – severe eye damage from laser beam.
3. Never look directly into the laser source.
4. To test function, hold an object in front of the line
laser exit point.
5. Align SCT 815 S3 with the vehicle's longitudinal cen‐
ter plane.
6. Draw two auxiliary lines
specified offset at right angles to the projected laser
line (1).
7. Use the two auxiliary lines to draw a line parallel to
the projected laser line.
8. Move SCT 815 S3 until the projected laser line of the
line laser converges with the drawn parallel line.
1
2 2
3
(1) Laser line on vehicle's longitudinal center plane
(2) Auxiliary lines
(3) Laser line adjusted by offset
1
(2)
of the length of the
Robert Bosch GmbH