Bosch SCT 815 S3 Manual Original página 6

en | 6 | SCT 815 S3
The metallic surfaces of the mount for the laser
range finder and the line laser may interfere with
calibration.
12. Use diagnostic software to calibrate the radar sen‐
sor.
---Separator---
4.2 Attaching the line laser to SCT 815 S3
1. Pay attention to the positioning pins
mount for the line laser.
2. Pay attention to the drill bushings
of the line laser.
5
4
1 1
3
(1) Positioning pins
(2) Drill bushings
(3) Magnet
(4) Retaining cable
(5) Retaining ring
3. Position the line laser with the drill bushings on the
positioning pins.
 The line laser is held in place by the magnet
the mount.
 The positioning pins are located in the drill bush‐
ings of the line laser.
 The line laser sits firmly in the mount and cannot
be twisted.
4. Secure the retaining cable
(5)
of the line laser on the mount for the line laser.
 The line laser is secured against falling.
---Separator---
4.3 Adjusting the distance between
SCT 815 S3 and the vehicle
The distance between SCT 815 S3 and the vehicle is
specified in the corresponding brief instructions. The
distance specific to the vehicle is found in the column
with the following pictogram.
1. Use the corresponding brief instructions.
2. Look up the distance between SCT 815 S3 and the
relevant vehicle.
1 689 989 477 | 2020-05-01
(1)
on the
(2)
on the bottom
2 2
(3)
in
(4)
on the retaining ring
3. Lift SCT 815 S3 by the guide tubes, and position it
at the specified distance in front of the center of the
vehicle by eye.
4. Position the mount for the laser range finder
the prismatic reflector (2).
1
2
(1) Mount for laser range finder
(2) Prismatic reflector
5. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence, SCT 815 S3
cannot be correctly aligned.
6. Insert the laser range finder
shelf (2).
(1)
on
1
(1)
(2)
in the
1
2
4712008-10_shd
(1)
into the horizontal
Robert Bosch GmbH