Publicidad
Idiomas disponibles
Idiomas disponibles
en | 4 | SCT 815 S3
• The area between the vehicle and SCT 815 S3 must
not contain metallic any objects.
• The area within a radius of 2 m around SCT 815 S3
must not contain any metallic objects.
4712008-12_shd
1
(1) Manufacturer-specific area between the vehicle and
SCT 815 S3 (see brief instructions)
(2) Area around SCT 815 S3
(3) SCT 815 S3
---
Diagnostic software
• Diagnostic software for calibrating the front radar
sensor
• If [ESI]tronic 2.0 is used as diagnostic software: info
type SD (control unit diagnosis) and KTS
---
2.5
Laser range finder GLM 400 CL
Only GLM 400 CL may be used as a range finder
for aligning SCT 815 S3.
The laser range finder GLM 400 CL is used to position
SCT 815 S3 in front of the vehicle and to adjust the
height of the prismatic reflector.
The following properties of the laser range finder
GLM 400 CL ensure that SCT 815 S3 can be positioned
precisely as specified in the brief instructions specific
to the vehicle:
• Continuous distance measurement
• Display of inclination angle
• Rear edge as reference point for distance measure‐
ment
---
2.6
Functional description
A prismatic reflector must be used to calibrate the front
radar sensor of the makes Mazda, Honda, Toyota, Kia
and Hyundai. For the front radar sensor to be calibra‐
ted, the prismatic reflector must be positioned in front
of the vehicle at a distance and height specific to that
vehicle. The adjustment device SCT 815 S3 is used to
put the prismatic reflector in that vehicle-specific posi‐
tion.
As soon as the prismatic reflector is in its vehicle-spe‐
cific position, the calibration must be started using di‐
agnostic software. The front radar sensor emits signals
focused and reflected back to the front radar sensor by
the prismatic reflector. The calibration will be success‐
ful if the prismatic reflector is precisely aligned. The
calibration may fail if the prismatic reflector is not pre‐
1 689 989 477 | 2020-05-01
cisely aligned or the measurement bay requirements
are not met.
---Separator---
3.
3.1
---Separator---
1. Make sure all components specified in the scope of
delivery are present.
2. Position the guide tubes with the tube connectors
3
(1)
2
(1) Guide tube with tube connectors
(2) Base plate
(3) Hex socket head cap screw
(4) Washer
3. Use the hex socket head cap screws
(4)
at 4 Nm.
4. Slide the preassembled tool holder
guide tubes, and use the knurled screw
it.
1
(1) Preassembled tool holder
(2) Knurled screw
5. Position the mount for the line laser
holes over the tube connectors on the guide tubes.
Initial commissioning
SCT 815 S3 installation
over the holes in the base plate.
4 Nm
1 1
3
4
2
to secure the tube connectors on the base plate
2
2
(3)
and washers
(1)
onto the
(2)
to secure
1
(1)
with the
Robert Bosch GmbH
Publicidad
