Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Prior to powering tools and equipment, make sure the generator's rated
voltage, and amperage capacity (220/230V AC @ 7 AMPs, 12V DC @ 8
AMPs) is adequate to supply all electrical loads that the unit will power. If
powering exceeds the generator's capacity, it may be necessary to group
one or more of the tools and/or equipment for connection to a separate
generator.
3.
Once the generator is running, simply connect the power cords of
220/230 volt AC powered tools and equipment into the 220/230 volt AC
dual outlets and/or the power cord of a 12V DC powered tool to the DC
terminals.
4.
DO NOT connect 3-phase loads to the generator.
5.
DO NOT connect 60Hz loads to the generator.
6.
DO NOT overload the generator.
NOTE
The DC terminals may be used for charging 12 volt type batteries only.
4.4
Parellel Connection within 2 generator
Performance: increase output through the parallel connection way within 2
sets of P2000i inverter generators.
Operation Guide:
1. 2 sets of P2000i inverter generators needed
Attention: generators are power off, without any loading equipments and
cable sockets.
INVERTER GENERATOR – P2000i
25
Publicidad
