Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect the terminal clamps in the following order:
Caution!
When disconnecting the jumper cables, be careful they do not come into
contact with the moving parts of the engine.
1. Negative lead (black) from earth
point of vehicle with drained
battery.
2. Positive (red) battery cable.
After jumpstarting drive the broken-
down vehicle for a longer distance
to charge the battery. You may also
recharge the battery with a charger.
Fully recharge the device after using it for jump starting (see "Charging
the device battery back").
Operating the compressor
Attention!
Always wear suitable hearing protection and suitable safety
glasses when using this product.
• Check the device and the air hose [16] for damage before every use! Do
not use the device if damaged!
• Observe the maximum pressure of the item you wish to inflate and read
the respective operating instructions.
1. Remove the air hose [16] from the storage compartment [15].
2. Select the desired valve adapter. Open the lock-on lever [17] by push-
ing the lock-on lever away from the air hose [16].
3. Now attach the valve adapters and push the lever toward the air hose
to lock it in place.
4. Verify the valve adapter is tight.
Inflating tyres
• The tyre pressure increases as the temperature rises. The recommend-
ed tyre pressure is typically specified for cold tyres (approx. 20 °C).
Please refer to the owner's manual for your vehicle.
• Do not check the tyre pressure on warm tyres (e.g. after long trips).
Attention!
The compressor may be operated for max. 10 minutes, after which the
device must cool down for 10 minutes!
1. No valve adapter required to inflate car tyres. First remove the cap
from the tyre valve.
EN
Original Operating Instructions
ON
12V
2
OFF
OFF
CONNECT
ON
USB
1
31
Publicidad
