Troubleshooting
Problem
Device isn't working.
Low output voltage.
The On/Off switch [11]
is on but the compres-
sor does not start
inflating.
The device is pumping
air but the tyre/item is
not inflating.
The pressure in the
tyre is less than the set
pressure.
Cleaning, care and maintenance
• Always disconnect the air and power station from the 230 V power
supply and disconnect external devices before cleaning or performing
maintenance.
• Allow the device to cool down completely before cleaning.
• To prevent corrosion, wipe off any battery fluid which may have come
into contact with the clamps.
• Keep the air inlets and outlets free from dirt and dust. Clean the device
with a damp cloth.
• Carefully wind the cables and hoses when storing the device. This will
help prevent accidental damage to the cable and the device.
• Store the machine in a clean, dry place.
34
Solution
Replace or charge the battery pack.
Check the connections and charge the battery
pack.
Verify the battery pack is charged.
Verify the chuck [17] is properly connected to
the valve of the tyre/item.
Check if the tyre/product is leaking air.
The tyre pressure increases as the temperature
rises. The recommended tyre pressure is typi-
cally specified for cold tyres (approx. 20 °C).
Do not check the tyre pressure on warm tyres
(e.g. after long trips). Please refer to the owner's
manual for your vehicle.
With large tyres such as on campers it's advis-
able to increase the pressure by 2 PSI (0.1 bar)
to compensate for the high volume.
Jump Starter