Put on your personal protective equipment before working on the machine.
Work on electrical components or equipment may only be carried out by a qualified electrician or
under the instruction and supervision of a qualified electrician.
15.3
Safety devices
The machine is equipped with the following safety devices:
15.4
General safety instructions
To avoid malfunctions, damage and health hazards when working with the machine, the following
points must be observed in addition to the general rules for safe working:
Before start-up, check the machine for completeness and function. Only use the machine if
•
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
Choose a level, vibration-free, non-slip surface for the installation location.
•
Ensure sufficient space around the machine!
•
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
Only use perfect tools that are free of cracks and other defects (e.g. deformations).
•
Remove tool keys and other adjustment tools before switching on the machine.
•
•
Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
•
Check the strength of the machine connections before each use.
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorised recommissioning.
•
The machine may only be operated, serviced or repaired by persons who are familiar with it
and who have been informed of the hazards arising from this work.
•
Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
When working on the machine, never wear loose jewellery, loose clothing, ties or long, open
•
hair.
Hide long hair under hair protection.
•
Wear close-fitting protective clothing and suitable protective equipment (eye protection,
•
dust mask, ear protection; gloves only when handling tools).
Metal dust can contain chemical substances that can have a negative effect on health.
•
Work on the machine should only be carried out in well-ventilated rooms. If necessary, use
a suitable extraction system.
If there are connections for dust extraction, make sure that they are properly connected
•
and in working order.
Always work with care and the necessary caution and never use excessive force.
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
•
A jaw chuck guard (1) with position switch. The
machine only switches on when the jaw chuck guard
is closed.
•
A protective cover on the headstock.
•
A spiral spring as a protective cover on the leadscrew
(prevents clothing from being drawn in).
SAFETY
39
ED300ECO