X-LITE X-552 Manual Del Usuario página 18

X-552
PEAK
The peak can be adjusted in different positions by turning it upwards or downwards
(Fig.1).
When riding on the road, the peak should be adjusted to the highest "0"position
(Fig.1)
1 ADJUSTMENT
1.1 Loosen the tightness of the upper central threaded cover plate "A" by turning it
counter-clockwise (Fig.2).
1.2 Turn the peak around the side cover plates "B" to adjust it to the desired position
(Fig.1).
1.3 Lock the peak in the desired position by tightening the upper central threaded
cover plate "A" (Fig.2).
2 DISASSEMBLY
2.1 Release the bayonet side cover plates "B" by turning them by 90° so that the peak
side ends are detached from the helmet shell (Fig.3). Be careful not to lose the two
trims placed between the peak and the shell, which should remain fastened to the
cover plates (Fig.4).
2.2 Completely unscrew the upper central threaded cover plate "A" by turning it coun-
ter-clockwise (Fig.2). Then remove the peak from the helmet.
3 ASSEMBLY
Check that the side cover plates "B" and the corresponding internal trims are properly
fastened to the peak as originally (Fig.4).
3.1 Place the peak on the shell; then insert the upper central threaded cover plate "A"
into the corresponding threaded hole and screw it in, turning it clockwise without
tightening it completely (Fig.2).
3.2 Insert the left side cover plate "B" into its corresponding housing on the shell and
lock it by turning it by 90°. Then repeat the operation on the other side of the hel-
met (Fig.3).
3.3 Complete the adjustment of the peak position as per the instructions above.
WARNING
- Make sure that the cover plates and their internal trims, which are interposed
between the peak and the helmet shell, allow the peak to be kept steady in the
desired position.
- Do not use the helmet if the peak has not been assembled and properly adjusted.
- Do not assemble the peak without the cover plate internal trims.
- The peak should always be assembled over the visor.
- When the peak is assembled, check that the visor is working properly by opening
and closing it completely.
- The peak is equipped with internal spacers to reduce the risk of damaging the
visor during the last stage of its opening; do not remove these spacers from the
peak.
18
INSTRUCTIONS FOR USE