X-LITE X-552 Manual Del Usuario página 25

8.3 Press the padding of the left cheek pad against the polystyrene cheek pad and
simultaneously turn it inwards to fasten the front hook placed on its rear part
(Fig.14).
8.4 Press at the two snap fasteners, front and top respectively, to fasten them to the
polystyrene cheek pad corresponding housings.
8.5 Press the safety lever upwards at the fastening area of the red strap to turn it
towards the cheek pad padding until it reaches its closing position (Fig.13).
8.6 Check whether the fasteners and hooks are correctly fastened by slightly pulling
the pad of the cheek pad towards the inside of the helmet and checking whether
it remains adherent to the polystyrene cheek pad.
8.7 Follow these operations with the right cheek pad padding.
WARNING
- If your helmet is equipped with the D-Ring retention system, close it as de-
scribed in the attached D-Ring instruction label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if all parts of the inner comfort padding have not been prop-
erly and correctly reassembled.
- Carefully wash by hand and use only mild soap and water at 30° C max.
- Rinse using cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is intended to change or
get partially destroyed to help absorb shocks.
- Do not modify or alter the internal polystyrene components in any way.
- Clean the inner polystyrene components using a damp cloth only and allow them
to dry at room temperature away from direct sunlight.
- Never use tools or equipment to carry out the operations described above.
LINER POSITIONING CONTROL ( LPC )
1 ADJUSTING THE LINER POSITION
The different anatomic shape of riders heads at times requires the position of the hel-
met to be adapted to the specific head. The LINER POSITIONING CONTROL (LPC)
enables the position of the liner to be adjusted. This means that, unlike a standard
helmet, the position of the helmet on the rider's head can be changed without changing
the size of the helmet, making it adaptable to multiple needs.
To adjust the liner, proceed as follows after releasing the liner rear part (see instructions
above).
1.1 Release the liner adjustment rear tab from the central locking pin on the liner rear
frame (Fig.23).
1.2 Pull the adjustment rear tab and fasten it to the central pin in one of the other 7
possible click positions.
By pulling the liner adjustment rear tab, the helmet is gradually positioned high-
er on the head, click after click.
1.3 Fully reassemble the liner into the helmet (see instructions above) being careful to
properly insert the adjustment tab into the cavity between the outer shell and the
polystyrene inner shell.
INSTRUCTIONS FOR USE
X-552
25