Dreame DreameBot D10s Manual Del Usuario página 9

Routine Maintenance
EN
Clean the Dust Bin and Filter
1. Open the robot cover, then press the dust bin clip to remove the dust bin.
2. Open the bin cover and empty the bin as shown in the diagram.
14
3. Remove the filter and tap its basket gently.
Note:
· Do not attempt to clean the filter with a brush, a finger or sharp objects to
prevent damage.
4.Rinse the dust bin and filter with water and dry them completely
before reinstalling.
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Note:
· Rinse the dust bin and filter with clean water only. Do not use any detergent.
· Use the dust bin and filter only when they are completely dry.
Routine Maintenance
Clean the Mopping Module
1. Slide the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with only water and leave it to
air-dry before re-installing.
Note: Do not expose the tank to the sun directly.
3. Clean the mop pad with water only and leave to air dry before re-installing.
12
11 1
10 2
24 hrs
9 3
8 4
7 6 5
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
4. If slow water flow occurs, or the outflow is not well-distributed, clean the air
hole in the cover of the water tank.
EN
15