Jeep Hemlock Manual Del Usuario página 17

*The autonomy of the battery supplied with the electrically power assisted cycle and, therefore, the relevant distance data
estimated in km, may vary significantly depending on the specific mode of use (total load transported, level of effort by
the rider, level of electric pedal assistance detected, how often the rider departs and restarts), mechanical and electrical
conditions of the product (tyre pressure and wear, battery efficiency level) and external influences (slopes and road surface,
atmospheric conditions).
Function description
Display on/off
Press the ON/OFF button for 2 seconds to switch the display on or off.
Selecting the assisted pedalling level
Press + or – button to increase or decrease the selected pedal assist level.
There are between 1 and 5 selectable levels of pedal assist.
Assist level 1 determines the setting of the minimum electrical power provided by the motor.
Assist level 5 determines the setting of the maximum electrical power provided by the motor.
To deactivate the electric motor support, press the - button until the display shows the numerical value of the pedalling
assistance level in use.
Enabling walk assist mode
After disabling the electric motor support, which is confirmed by the absence of indication of the numerical value of the
pedalling assistance level in use on the display, briefly press the - button until the WALK symbol is displayed.
Press the - button to enable the walk assist function, indicated by the intermittent presence of the WALK symbol, which
allows activating an electric motor support up to a maximum speed of 6 km/h.
Disable the function by releasing the - button.
CAUTION
The walk assist mode must be used in compliance with the regulations in force in the country of use and is only allowed when
pushing the electrically power assisted cycle and walking alongside it holding the handlebar grips firmly with both hands.
DANGER
It is strictly prohibited to enable the walk assist mode when you are sitting on the saddle of the electrically power assisted
cycle to avoid the danger of injury and the risk of damaging the electrical components of the bike.
Switching the light on/off
Press the light on/off button for 2 seconds to turn the front light on or off and enable/disable the display backlight.
The front light and backlight of the display screen will be automatically activated in case of poor lighting based on the value
of the "light sensitivity sensor" parameter set via the configuration menu.
Data display (TRIP - TOTAL - MAXS - AVG - RANGE)
Shortly press the i button to view in sequence the available use data related to distance (TRIP, TOTAL and RANGE) and speed
(AVG and MAX); data display sequence: TRIP - TOTAL - MAXS - AVG - RANGE
Partial and/or temporary use data for TRIP, MAXS and AVG can be reset as follows:
quickly press the i button twice to access the setting MENU in which the tC parameter will be displayed; using the value
variation buttons, select the letter y and then press the + button for about 2 seconds.
Indicator light for residual battery charge
The battery charge level is shown on the display screen as a number of dashes between 0 and 10.
If there are 10 dashes, it means that the battery is charged to the maximum percentage defined and detected instantly.
Less dashes are shown to indicate a decrease in the battery charge level available and subsequent autonomy.
The level of the battery charging indicator may fluctuate depending on how the electrically power assisted cycle is
being used, for example, when going up a slope, the level displayed can drop rapidly as there is a much higher battery
consumption.
The individual dashes indicate the specific battery charge range detected at the time and do not necessarily indicated a
percentage of the residual autonomy.
Malfunction indicator light
If a malfunction of the product's electrical and/or electronic system is detected, the relevant warning light will appear on the
display screen and the corresponding identification Malfunction Code will be displayed at the same time.
16