Fimap FV-CART Manual De Instrucciones página 22

12. Clean the inside of the vacuum hose with a jet of compressed air, if necessary removing any obstructions.
13. Disconnect the accessory used for the cleaning, clean the inside of the vacuum chamber of the accessory with compressed air, and if
necessary remove any obstructions.
14. Repeat the operations in the reverse order to reassemble everything
ENG
This chapter lists the most common problems linked with the use of the machine. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance centre.
PROBLEM
TROUBLESHOOTING
POSSIBLE CAUSE
The main switch is not activated.
There is no battery on the lower part of the tank of the
vacuum cleaner.
The battery is not charged.
The battery charger does not charge the battery, the
electronic specifications of the battery charger do not
match the electronic specifications of the mains supply.
The battery charger power cable is damaged.
The vacuum hose is not connected correctly to the
collection tank.
The vacuum hose is not connected correctly to the
telescopic hose.
The accessory being used is not connected correctly to
the telescopic hose.
The vacuum circuit is blocked (vacuum hose; telescopic
hose; vacuum accessory).
There is a blockage in the vacuum filters.
Dispose of the machine in accordance with the waste disposal regulations in force in the country in which the machine
is being used.
Place the main switch on "I".
Insert the battery into the battery compartment at the rear
of the machine, ensuring that the battery poles are facing
towards the top of the machine. Press the battery until the
catch clicks into position.
Recharge the battery, read the paragraph
"RECHARGING THE BATTERY" on page 18.
Check that the technical data on the battery charger's
serial number plate match the data of the mains supply.
Contact a specialised technician immediately and replace
it.
Connect the vacuum hose correctly to the collection tank.
Connect the vacuum hose correctly to the telescopic
hose.
Connect the accessory correctly to the telescopic hose.
Remove the obstruction in the vacuum circuit.
Clear the obstruction in the vacuum filters.
DISPOSAL
22
SOLUTION