Stihl BG 56 Manual De Instrucciones página 6

!
Warning!
Never modify a blower in any way. Only
attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL blower models
are authorized. Although certain
unauthorized attachment are useable for
the STIHL blower, their use may be
extremely dangerous.
THE USE OF THE BLOWER
Transport
Always turn off the engine before putting
down blower. When transporting your
unit in a vehicle, properly secure it to
prevent turnover, fuel spillage and
damage to the machine.
Fueling
This STIHL unit uses an oil-gasoline
mixture for fuel (see the chapter on
"Fuel" of your owner`s manual).
!
Warning!
Gasoline is an extremely
flammable fuel. If spilled
or ignited by a spark or
other ignition source, it
can cause fire and serious
burn injury or property
damage.
BG 56, BG 66, BG 66 C, BG 86, SH 56, SH 86
Use extreme caution when handling
gasoline or fuel mix.
Do not smoke or bring any fire or flame
near the fuel.
Fueling instructions
Fuel your machine in well-ventilated
areas, outdoors only. Always shut off the
engine and allow it to cool before
refueling. Relieve fuel tank pressure by
loosening fuel cap slowly. Never remove
fuel filler cap while engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Avoid
spilling of fuel or oil. Wipe off any spilled
fuel before starting your blower and
check for leakage.
Always tighten fuel filler cap securely
after fueling.
!
Warning!
Check for fuel leakage while refueling
and during operation. If fuel or oil
leakage is found, do not start or run the
engine until leak is fixed and spilled fuel
has been wiped away. Take care not to
get fuel on your clothing. If this happens,
change your clothing immediately.
Always store gasoline in a container
approved for flammable liquids.
English / USA
!
Warning!
Unit vibrations can cause an improperly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
In order to reduce risk of
fuel spillage and fire,
tighten fuel cap by hand
with as much force as
possible.
Before Starting
!
Warning!
Never operate your machine if it is
damaged, improperly adjusted or not
completely and securely assembled.
You should always inspect your unit
before starting it. Make sure the unit is
properly assembled, in good operating
condition and the controls and safety
devices are working properly.
!
Warning!
To reduce the risk of injury from thrown
parts, check your fanwheel and fan
housing for damage (cracks, nicks,
chipping). If any damage is found, stop
using the unit and contact your STIHL
dealer for repair.
: Throttle trigger must move freely
and spring back to idle position
when released.
5