Introduction
This manual is a follow on from the installation guide provided with your caravan
movers. Please read the installation guide thoroughly prior to attempting anything
described in this Electronics installation guide and user manual.
Thank you for choosing these caravan mover electronics. This product has been produced according
to high standards and has undergone careful quality control procedures. Simply by using the remote
control you can move your caravan effortlessly into any position required within operating guidelines.
Before continuing with installation and starting to use the mover, please read this manual
very carefully and be aware of all the safety instructions! The owner of the caravan will
always be responsible for correct use. Keep this manual inside your caravan for
future reference.
This electronics installation and User Manual covers the steps required to electrically wire your Basic
electronics to your given caravan movers. On auto-engage mover models, the remote control handset
enables you to simultaneously engage the rollers of movers in any given setup. Once engaged, your
handset will allow you full directional control of your caravan, providing accurate manoeuvring and
features such as on the spot rotation (single axle mode only).
Installation - Safety Guidelines
Read this User Manual carefully before installation and use. Failure to comply with these
rules could result in serious injury or damage to property.
Before starting installation of the caravan mover:
DO check that the caravan is disconnected from the battery supply and the mains electrical supply.
DO only use adapters and accessories that are supplied or recommended by the manufacturer.
DO check that the tyres are not over worn (fitting to new or nearly new tyres is the best option).
DO make sure that the tyre-pressures are correct to the manufacturer's recommendation.
DO make sure the chassis is in good condition without any damage and is free from rust, dirt etc.
DO stop work immediately if you are in doubt about the assembly or any procedures and consult one
of our engineers.
DO locate the battery isolation switch to be accessible at all times when parking and moving the
caravan.
DO NOT remove, change or alter any parts of the chassis, axle, suspension or brake mechanism.
DO NOT operate the unit if you are under the influence of drugs, alcohol or medication that could
impair your ability to use the equipment safely.
EN 10