English
Information applied directly to the product, such as:
• direction of rotation arrow,
• identifiers for connections,
• name plate,
• and warning sticker,
must be strictly complied with and kept in legible condition.
2.2 Qualified Personnel
The personnel installing the pump must have the appropriate qualifications for
this work. Area of responsibility, terms of reference and monitoring of the per-
sonnel are to be ensured by the operator. If the personnel are not in possession
of the necessary knowledge, they are to be trained and instructed. This can be
accomplished if necessary by the manufacturer of the product at the request of
the operator.
2.3 Risks incurred by failure to comply with the safety precautions
Non-observance of the safety instructions can result in risk of injury to persons
and damage to the environment and the product/unit. Failure to comply with
the safety instructions results in the loss of any claims to damages.
Failure to comply can, for example, result in the following risks:
• danger to persons from electrical, mechanical and chemical hazards,
• damage to the environment due to leakage of hazardous materials,
• damage to property,
• failure of important product/unit functions,
• failure of required maintenance and repair procedures.
2.4 Safety consciousness on the job
The safety instructions provided in the installation manual are to be observed in
accord with any national, local and municipal safety requirements.
2.5 Safety precautions for the operator
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• If hot or cold components on the product/the unit lead to any hazards, local
measures must be taken to prevent their exposure.
• Leakage (i.e. from a shaft seal) of hazardous (i.e. explosive, toxic or hot) fluids
must be discharged so that no danger to persons or to the environment arises.
National, local and municipal statutory provisions are to be complied with.
• Highly flammable materials are always to be kept at a safe distance from the
product.
• Danger from electrical current must be eliminated. National Electrical Codes,
local codes and regulations must be followed.
4
Subject to technical alterations!
WILO SE 02/2016