Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
individuals with disabilities.
Items supplied
The main parts of the appliance are:
• An outer casing made using galvanised steel.
• A polystyrene counter cross flow heat exchanger, whose
particular morphology guarantees a very high heat exchange
efficiency. H models are equipped with an enthalpy
exchanger, which is also able to transfer the humidity present
in the air.
• Two energy-saving variable-speed brushless motors (3
preset speeds + boost speed).
• An electronic controller supervising the power input,
regulation and control of the appliance.
• Control box.
• 4 temperature sensors.
• 2 ePM10 50% filters (M5).
• Temperature sensors.
• Outer HMI display.
Key to air connections (fig.2)
A: Clean air outlet inside the room.
B: Stale air intake from room.
C: Fresh air intake from outside.
D: Stale air outlet to outside.
Unit placement
The appliance must be installed at least 2.3 meters from the
floor (see fig. 3).
Make sure there is adequate access for installation and
maintenance. Make sure that the chosen wiring of the mains has
a disconnect switch nearby for maintenance.
NOTE: The appliance is used only for suspended operation. The
unit is typically installed in a false ceiling but, if this is not
possible, it can be placed on a mezzanine or in any suitable
position. Also make sure also that the accessibility and location
of the electrical services are taken into consideration. It is the
responsibility of the installer to ensure that all aspects of the
system design are taken into account.
NOTE: The system is designed as a ducted unit and should only
be used in the presence of piping.
Make sure that the pipes are supported along their entire length.
NOZZLES
The unit is equipped with four 125 mm (VORT HRI 200 FLAT
IoT / H) and 150 mm (VORT HRI 350 FLAT IoT) nozzles.
Each nozzle is marked with a label indicating the direction of the
air flow. Make sure the correct piping is connected to the cor-
rect vents.
34
2 2
B
A
3
C
D
Publicidad
