Publicidad
Idiomas disponibles
Idiomas disponibles
too slow (a drop at a time), this can be corrected by adjusting
the grinding adjustment dial (A5 - fig. 13).
Please note!
The grinding adjustment dial must only be turned when the
coffee grinder is in operation during the initial phase of coffee
preparation.
If the coffee is delivered too slowly or not
at all, turn one click clockwise towards 7.
For fuller bodied creamier coffee, turn
one click counterclockwise towards 1 (do
not turn more than one click at a time
otherwise the coffee could be delivered
a drop at a time).
These adjustments will only be evident after at least 2 cups of
coffee have been delivered. If this adjustment does not obtain
the desired result, turn the dial another click.
8.6 Tips for a hotter coffee
For hotter coffee, you should:
•
perform a rinse cycle by selecting the "Rinsing" function in
the settings menu (section "7.1 Rinsing
•
warm the cups with hot water using the hot water function
(see section "10. Delivering hot water");
•
increase the coffee temperature in the settings menu (B8)
(see section "7.10 Coffee temperature ").
9. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note!
•
To avoid milk with poor froth or large bubbles, always clean
the milk container lid (D2) and hot water connection noz-
zle (A9) as described in sections "9.4 Cleaning the milk con-
tainer after use","14.10 Cleaning the milk container" and
"14.11 Cleaning the hot water/steam connection nozzle".
13
");
14
9.1 Filling and attaching the milk container
1. Remove the lid (D2) (fig. 14);
14
2. Fill the milk container (D3) with a sufficient quantity of milk,
not exceeding the MAX level marked on the container (fig.
15). Each mark on the side of the container corresponds to
about 3.38 floz /100 ml of milk;
Please note!
•
For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
41°F/5°C).
•
If "Energy Saving" mode is enabled, you may have to wait
a few seconds before the beverage is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
the bottom of the milk container lid (fig. 16);
16
4. Place the lid back on the milk container;
5. If present, extract the hot water/steam spout (C6) by press-
ing the release button (C7) (fig. 17);
6. Attach the milk container (D) to the connection nozzle (A9)
(fig. 18) and push as far as it will go. The machine emits a
beep (if the beep function is enabled);
15
17
Publicidad
