Publicidad
Idiomas disponibles
Idiomas disponibles
14.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
29
1. Make sure the machine is correctly turned off (see section
"6. Turning the appliance off");
2. Remove the water tank (A16) (fig. 3);
3. Open the infuser door (A18) (fig. 29) on the right side of
the appliance;
4. Press the two colored release buttons inwards and at the
same time pull the infuser outwards (fig. 30);
31
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO SOAP - NO DISH WASHER
Clean the infuser without using washing up soap as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 31), then push the PUSH symbol fully
in until it clicks into place;
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 32.
8. Once inserted, make sure the two colored buttons have
snapped out (fig. 33);
30
9. Close the infuser door;
10. Put the water tank back.
14.10 Cleaning the milk container
To keep the frother efficient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 34);
3. Turn the froth adjustment dial (D1) counterclockwise to the
"INSERT" position (fig. 34) and pull it off upwards;
32
4. Wash all the components thoroughly with hot water and
mild soap. All components are dishwasher safe, plac-
ing them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 35). If necessary, scrape the
groove with a toothpick;
20
33
34
Publicidad
