Publicidad
Idiomas disponibles
Idiomas disponibles
35
5. Rinse inside the froth adjustment dial seat with running
water (fig. 36);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
14.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A9)
with a sponge to remove milk residues from the gaskets (fig.
22).
15.
DESCALING
Important!
•
Before use, read the instructions and the labeling on the
descaler pack.
•
You should use De'Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's warranty.
Descale the appliance when "DESCALING NEEDED - PRESS OK TO
START (~45min)
" appears on the display (B1): To des-
cale immediately, press the selection arrow (B2) corresponding
to "
OK" and follow the instructions from point 4.
To descale the appliance later, press the selection arrow (B2)
corresponding to "
ESC". The
display to remind you that the appliance needs descaling. (the
message appears each time you turn the appliance on).
To access the descaling menu:
1. Press the selection arrow (B2) corresponding to the "
symbol (B8) to enter the menu;
2. Press the selection arrow (B2) corresponding to "descale
" and follow the instructions on the display;
3. "REMOVE WATER FILTER" (fig. 37): extract the water tank
(A16), remove the water softener filter (C4) (if present)
36
symbol appears on the
"
21
and empty the water tank. Press the selection arrow cor-
responding to "NEXT>";
4. "DESCALER (LEVEL A) AND WATER (LEVEL B)" (fig. 38); Pour
the descaler into the tank up to the level A marked inside
the tank (equal to one 3.38 floz /100 ml pack), then add
water (one litre) up to level B and put the water tank back.
A
5. Press the selection arrow corresponding to "NEXT>";
6. "EMPTY DRIP TRAY" (fig. 39): Remove, empty and replace
the drip tray (A14) and grounds container (A10). Press the
selection arrow corresponding to "NEXT>";
7. "POSITION 2l CONTAINER OK TO START": Place an empty
container with a minimum capacity of 2 liters under the
hot water/steam spout (C6) and brewing unit (A8) (fig. 8);
Important! Danger of burns
Hot water containing acid flows from the hot water/steam and
brewing unit. Take care to avoid contact with splashes of this
solution.
8. Press "
OK" to confirm that you have added the descal-
ing solution. "DESCALING UNDERWAY" is displayed:
The descale program starts and the descaler liquid comes
out of the hot water and brewing unit. A series of rinses is
+
B
B
A
38
39
Publicidad
