Descargar Imprimir esta página

IKRA IBKH 33-1 Instrucciones De Manejo página 45

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 84
vibrations are a warning against operating failure.
The ON/OFF switch must not be locked.
Before work, check the area for any hidden items such as
wire fences.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.
The protective equipment on the appliance is strictly
prohibited to be disassembled, changed, used in conflict
with the designation and it is prohibited to attach any
protective equipment of other manufacturers.
When being blocked, turn the appliance immediately off
and remove the jammed item.
Do not run! Immediately remove cut branches/knots from
the work area to prevent injuries. Watch out for falling
branches!
Despite the observance of the operating instructions there
still may be some hidden residual risks.
CAUTION
Risk of injury
• All protection covers and safety devices must be correct-
ly attached to operate the device.
• Keep all parts of the body away from the cutter blade.
Do not remove cut material or hold material to be cut
when blades are moving. Make sure the switch is off
when clearing jammed material.
• Avoid any inadvertent starting of the engine. Make sure,
that the control lever is always in
'Start' position when you pull the starter rope.
• Switch the engine off and remove the socket plug before
any work on the engine. Wait until all rotating parts have
stopped and the appliance has cooled down.
• Check all screw and plug-in connections and protective
equipment if firm and tightened properly and whether
all moving parts are running smooth whenever the
appliance is to be put into operation.
• The protective equipment on the appliance is strictly
prohibited to be disassembled, changed, used in conflict
with the designation and it is prohibited to attach any
protective equipment of other manufacturers.
• The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
CAUTION
Damage to health arising from vibrations
to hand and arms if the device is used for a long time
or if the device is not guided and evaluated properly.
Vibration damping systems are no guaranteed protection
against white finger disease or carpal tunnel syndrome.
Therefore, it is necessary to carefully check the state of
your fingers and wrist if you have regularly used the appli-
ance for a long time. If any symptom of the diseases above
appears, seek medical advice immediately. To reduce the
white finger disease risk, keep your hands warm and take
regular breaks during your work.
CAUTION
Hearing damage
A longer stay in the immediate vicinity of the running
unit may cause hearing damage. Wear ear protectors!
When working with the device, a certain level of noise
cannot be avoided. Noisy work should be scheduled for
hours, during which it is allowed by statute or other local
regulations. Adhere to any applicable rest times and limit
your working time to the necessary minimum time. For
your personal protection and the protection of people
nearby, suitable hearing protection must be worn.
Noise emission information in accordance with the
German Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work can
exceed 80 dB(A). In such cases the operator will require
noise protection (e.g. wearing of ear protectors).
Please observe the following: according to the German
Machine Noise Protection Regulation from September
2002, this device may not be operated on Sundays
and Bank holidays or working days from 8pm to 7am.
Furthermore, it is forbidden to operate the machine at the
following times of day: from 7 a.m. to 9 a.m., from 1 p.m. to
3 p.m. and from 5 p.m. to 8 p.m.
Please do also consider any local regulations concerning
noise protection!
WARNING
Never attempt to operate your power tool with one hand.
Loss of control of the power tool resulting in serious or
fatal injury may result. To reduce the risk of cut injuries,
keep hands and feet away from the cutting tool. Never
touch a moving cutting tool with your hand orany other
part of your body.
GB
ENGLISH
45

Publicidad

loading