Husqvarna TC 112 Manual De Usuario página 15

To install and adjust the full bag sensor
1. Stop the engine and apply the parking brake.
2. Remove the center chute. Refer to
install the center chute on page 29 .
3. Install the full bag sensor (A) with the 2 screws (B).
C
4. Connect the cable (C). The connector for the cable is
found in the hole for the center chute.
5. To adjust the full bag sensor, push the lever in or pull
the lever out. If the grass is heavy or wet, push the
lever in. If the grass is dry and not heavy, pull the
lever out.
1903 - 002 - 06.02.2023
To assemble the grass catcher
1. Install the front frame (A) to the brackets on the top
To remove and
A
B
2. Install the strut (E) to the front frame and the top
3. Attach the rubber tube elements to the front frame.
frame (B) with 2 screws (C) and 2 nuts (D) on each
side.
D
F
G
E
G
frame with 2 screws (F) and 2 nuts (G) on each side.
B
C
A
F
15