Publicidad
Idiomas disponibles
Idiomas disponibles
5. Turn the ignition key to the start position. When the
engine starts, immediately release the ignition key.
The ignition key goes back to the ON (I) position
automatically when you release it.
CAUTION:
starter for more than 5 seconds at a
time. If the engine does not start, wait
15 seconds before you try again.
6. Let the engine operate at half throttle for 3–5 minutes
before you apply heavy load.
7. Push the throttle control to the full throttle position
(B).
A
CAUTION:
when the engine is at full speed causes
strain on the drive belts. Engage the cutting
deck before you put the throttle control in the
full throttle position.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged.
CAUTION:
out or push in the lever. Do not use middle
positions.
The lever to engage or disengage the drive system is
found behind the right rear wheel.
18
Do not operate the
B
To engage the cutting deck
Make sure that you fully pull
•
Push the lever in fully to engage the drive system.
•
Pull the lever out fully to disengage the drive system.
To apply and release the parking brake
•
To apply the parking brake, do the steps that follow.
a) Push down the parking brake pedal (A) fully and
pull up the parking brake lock (B).
b) Release the parking brake pedal.
•
To release the parking brake, push down on the
parking brake pedal and release it.
To engage and disengage the cutting
deck (TC 112)
WARNING:
deck without a grass catcher or other
accessory installed to the grass discharge.
A
Do not operate the cutting
1903 - 002 - 06.02.2023
B
Publicidad
