Publicidad
Idiomas disponibles
Idiomas disponibles
1. Open the engine cover.
2. Disconnect the headlight wire connector (A).
3. Tilt the engine cover forward and lift it to remove it
from the product.
4. Install the engine cover in the opposite sequence.
To replace the headlight bulb
1. Open the engine cover.
2. Turn the bulb holder slightly counterclockwise and
pull it out from the reflector.
3. Replace the bulb in the bulb holder.
4. Push the bulb holder into the reflector.
5. Turn the bulb holder slightly clockwise to install it.
6. Close the engine cover.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Apply the parking brake. Refer to
release the parking brake on page 18 .
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Push the parking brake pedal again to release the
parking brake.
To replace the fuel filter
1. Open the engine cover to get access to the fuel filter.
2. Close the fuel shut-off valve.
3. Compress the fuel tank hose to prevent leakage.
4. Move the hose clips away from the fuel filter with a
pair of flat pliers.
5. Pull off the fuel filter from the hose ends. A small
quantity of fuel can leak.
6. Push the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
1903 - 002 - 06.02.2023
To apply and
7. Push the hose clips against the fuel filter.
To clean and replace the air filter
1. Open the engine cover.
2. Loosen the knobs that hold the air filter cover and
remove the cover.
3. Remove the air filter cartridge from the filter housing.
25
Publicidad
