Dreame Bot L10 Ultra Manual Del Usuario página 8

Before Use
EN
1. Remove the protective strips
2. Install the Side Brush and the Mop Assembly
Side Brush Clip
Note: Install the side brush until it clicks into place.
10
3. Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good Wi-Fi
signal. Insert the power cord into the base station and plug it into the socket.
Firmly insert the power
cord upwards until the
I：ON
indicator turns on.
O：OFF
4. Place the Base Station
Remove any objects that are closer than 1.5 m from the front, 1 m from the top,
and 0.5 m from either side of the base station.
> 1 m
> 0.5 m
> 0.5 m
> 1.5 m
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood floors or carpets, placing the base
station on tile floors or marble floors is recommended.
Before Use
5. Place the Robot
Press and hold the button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station and starts charging. After the robot
is fully charged, the status indicators on the robot and the base station will
remain lit for 10 minutes and will then dim.
Note: It is recommended to fully charge the robot before its first use. When the
robot cannot be turned on after the battery is depleted, manually connect the
robot with the station to charge it.
6. Add Water to the Clean Water Tank
Take out the clean water tank from the base station, and fill it with clean
water up to the max water line. Then install it back into the base station.
MAX Water Line
Note:
·
Do not add hot water to the water tank, as this may cause the tank to become
deformed.
·
Do not add any liquid other than the officially-approved cleaner to help prevent
base station malfunction.
EN
11